Replaced Garmin GMC 307 with Garmin GMC 507 Autopilot Control Module (Garmin Automatic Flight Control System (AFCS) Mode Controller).
-
10/06/2020
Replaced Garmin GMC 307 with Garmin GMC 507 Autopilot Control Module (Garmin Automatic Flight Control System (AFCS) Mode Controller). New GMC 507 communicates via CAN Bus instead of RS-232, adds additional flight director button.
- KAI Page 44BiS-01 REV 1: In figure, “GMC 507” was “GMC 307”, updated depiction of GMC.
- KAI Page 44BiS-01 Rev 1: Figure 1 callout “USE SCREW, NUT, AND WASHER ALREADY INSTALLED, ATTACH SERVO GROUND HERE” was “USE SCREW, NUT AND WASHER ALREADY INSTALLED”.
- In Step 2, appended “Attach the servo ground wire as shown.”
- KAI Page 44BiS-03 REV 1: In Figure 1 callout, “MS21042-3” was “MS21042-10”.
- KAI Page 44BiS-04 REV 1: In Step 9, “If not already installed, locate the autopilot disconnect…” was “Locate the autopilot disconnect…”. Autopilot disconnect switch also installed in 42MiS/U-12 Figure 3.
- In Figure 3, “SCREW 0608MPP-BO” was “MS35214-26” and “WASHER 90295A380” was “NAS1149FN632P”. Updated hardware depiction accordingly.
- KAI Page 44BiS-05 REV 1: In Step 3 and Note, “GMC 507” was “GMC 307”.
- In Steps 1 and 2, “GMC 507” was “GMC 307”.
- In Figures 1 and 2, “GMC 507” was “GMC 307”. In Figure 2, updated depiction of GMC.
- KAI Page 44BiS-08 REV 1: In Note after Step 2, “GMC 507” was “GMC 307”.
- In Step 9, “GMC 507” was “GMC 307” and “379 in-lb” was “373 in-lb”.
- In Step 12, “GMC 507” was “GMC 307”.
- In Step 13 (SLSA), “GMC 507” was “GMC 307” and “SL-00016” was “N 18-11-14”.
- WH-00134-1 REV 0: Replaces WH-00134
See CN-00014 for additional changes to POH, MM, FTS, 42MiS/U, 42PiS/U, 53BiS, G3X-PRE-SETS-READ-ME-05-07-20, and WH-00136-1.
